Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MOWING TIPS
CAUTION: Do not use de-thatcher blade
attachments on your mower.
attachments are hazardous, will dam-
age your mower and could void your
warranty.
•
Under certain conditions, such as very tall grass, it
may be necessary to raise the height of cut to reduce
pushing effort and to keep from over load ing the en gine
and leaving clumps of grass clippings. It may also be
necessary to reduce ground speed and/or run the
lawn mower over the area a second time.
•
For extremely heavy cutting, reduce the width of cut
by overlapping pre vi ous ly cut path and mow slowly.
•
For side discharge operation, cut in a coun ter clock wise
di rec tion, start ing at the outside of the area to be cut,
in order to spread grass clip pings more evenly and
to put less load on the engine. To keep clip pings off
of walkways, flower beds, etc., make the first cuts in
a clock wise direction (See Fig. 13).
•
If a trail of grass clipping is left on the right side of the
lawn mower during rear discharge operation, mow in
a clockwise direction with a small overlap to collect
the clippings on the next pass.
•
Pores in cloth grass catchers can become filled with
dirt and dust with use and catchers will collect less
grass. To prevent this, regularly hose catcher off with
water and let dry before using.
•
Keep top of engine around starter clear and clean of
grass clippings and chaff. This will help engine air flow
and extend engine life.
OPERATION
Such
FIG. 13
MULCHING MOWING TIPS
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER
HOUSING FREE OF BUILT-UP GRASS AND TRASH. SEE
"CLEANING" IN MAINTENANCE SECTION OF THIS MANUAL.
•
The special mulching blade will recut the grass clip-
pings many times and reduce them in size so that
as they fall onto the lawn they will disperse into the
grass and not be noticed. Also, the mulched grass
will biodegrade quickly to provide nutrients for the
lawn. Always mulch with your highest engine (blade)
speed as this will provide the best recutting action of
the blades.
•
Avoid cutting your lawn when it is wet. Wet grass tends
to form clumps and interferes with the mulching action.
The best time to mow your lawn is the early afternoon.
At this time the grass has dried, yet the newly cut area
will not be exposed to direct sunlight.
•
For best results, adjust the lawn mower cutting height
so that the lawn mower cuts off only the top one-third
of the grass blades (See Fig. 14). If the lawn is over-
grown it will be necessary to raise the height of cut to
reduce pushing effort and to keep from overloading
the engine and leaving clumps of mulched grass. For
extremely heavy mulching, reduce your width of cut
by overlapping previously cut path and mow slowly.
•
Certain types of grass and grass conditions may require
that an area be mulched a second time to completely
hide the clippings. When doing a second cut, mow
across (perpendicular) to the first cut path.
•
Change your cutting pattern from week to week. Mow
north to south one week then change to east to west
the next week. This will help prevent matting and
graining of the lawn.
10
MAX 1/3
FIG. 14
Publicité
Chapitres
Table des Matières
