Before The First Use - Homa HCM-7520 Instructions D'utilisation

BEFORE THE FIRST USE

To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with warm water as following:
1. Pull out the water tank of the coffee maker. Pour water into water tank, the water level should not exceed the "MAX"
mark in the tank, then insert it into the coffee maker.
2. Note: The appliance is supplied with a removable tank for easy cleaning, you can fill the tank with water firstly, and then
insert the tank into the appliance.
3. Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel under the metal funnel holder (see
Fig.1), and turn it anticlockwise until it is fixed tightly (see Fig.2 and Fig.3).
Fig.1
4. Place an espresso cup you have prepared on drip plate. Make sure the steam knob is at the "O" position.
5. Note: As the appliance is not equipped with any cup or jug, prepare your own jug or cup.
6. Connect into power source, press down the ON/OFF button "
illuminated.
7. Press down the pump control button"
pump by pressing the pump control button"
8.
Make sure the coffee/steam button"
preheating until the coffee indicator (green) illuminates, it means that the preheating is finished.
9. Press down the pump control button"
10. After water has flown for 1 minute, press the pump control button "
then clean them thoroughly, now you can start brewing coffee.
Note: There may be noise when pumping the water for the first time, it is normal, as the appliance is releasing the air in the
appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance before making coffee, including the
funnel and cup, so that the coffee flavour will not be influenced by the cold parts.
1. Remove the removable water tank and fill it with desired water, the water level should be between the "MAX" mark and
the "MIN" mark in the tank. Then insert the tank into the appliance properly.
2. Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel under the metal funnel holder (see
Fig.1), and turn it anticlockwise until it is fixed tightly (see Fig.2 and Fig.3).
3. Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam knob is at the "O" position.
5. Press the ON/OFF button "
coffee/steam button"
6
EN: ESPRESSO MAKER | Instruction Manual
", the pump will pump water, when there is water flowing out and close the
"/ " " is at the higher position and wait for a moment, the appliance begin
" again, and water will flow out.
" to turn on the unit, the power indicator (red) will illuminate, make sure the
"/" " is at the higher position.
Fig.2
" to turn on the unit. The power indicator (red) will be
" again.
", you can pour out the water in each container
Fig.3