Using The Headphones - SilverCrest HG00593A Instructions D'utilisation Et Consignes De Sécurité

Note: The LED will flash red and blue whilst charging. Once the
battery is fully charged, the LED will remain blue.
Once charging has completed, remove the micro-USB plug from
the headphones.

Using the headphones

Connect the headphones with a communication device.
Place the headphones near a switched on communication device
(e.g. mobile or computer).
Pairing with a new Bluetooth device: Hold the button
®
8
for approx. 6 seconds until the LED flashes red and blue and
5
you hear two beeps. This indicates the headphones are now in
pairing mode, which remains active for 5 minutes. The device will
switch off if it does not detect a Bluetooth device to connect to
®
and sound 4 beeps.
Now connect your communication device (mobile phone or com-
puter) via Bluetooth with the headphones. Please refer to the
®
notes in the instructions for your communication device. Select the
entry „HG00593" from the list of devices detected by your com-
puter or mobile. If prompted, enter code „0000" to establish the
connection.
Once the connection has been established, the LED will briefly
flash twice every 4 seconds.
If you want to connect a another device to the headphones, re-
peat the pairing as described previously.
Please note, your communication device must support Bluetooth
®
Standard 4.0 to use all options.
If you come into range of the paired device with the headphones
switched on, a Bluetooth connection will automatically be
®
established.
GB/IE 13