Makita SP6000 Manuel D'instruction page 7

Turn the positive stopper so that the arrow on it points
one of two positions (vertical for 22.5°, horizontal for
45°). Loosen the clamping screws in front and back.
Then, tilt the tool base until it stops and secure the base
with the clamping screws.
To get 48° bevel angle, move the lever to 48° marking
as far as it will go. Turn the positive stopper so that the
arrow on it points to the horizontal position. Then, tilt
the tool base until it stops and secure the base with the
clamping screws.
► 1. Lever
Tilting to the left
1
► 1. Bevel angle shifting lever
The tool can be tilted to the left 1° bevel angle. To get
the left 1° bevel angle, loosen the clamping screws in
front and back, tilt the tool handle slightly to the right
and push two bevel angle shifting levers at the same
time in the direction of arrow which has a marking -1.
And then tilt the tool handle to the left while pushing
these two levers at the same time. Secure the base with
the clamping screws.
NOTE:
• Returning the blade to the right angle makes the
shifting lever return to 0° by itself.
Sighting
1
► 1. Base 2. Cutting line
When using the tool without guide
rail (accessory)
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
When using the tool with guide rail
(accessory)
For both straight cuts and 45° bevel cuts, always align
the A position on the front of the base with your cutting
line.
Switch action
2
► 1. Lock-off button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
7 ENGLISH
1
1
2
A
B