Functional Description - Makita SP6000 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting depth of cut
2
► 1. Clamping screw 2. Blade lower limit stopper
CAUTION:
• After adjusting the depth of cut, always tighten
the clamping screw securely.
Loosen the clamping screw on the depth guide and move the
blade lower limit stopper to the desired depth on the scale plate.
At the desired depth of cut, tighten the clamping screw firmly.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.
NOTE:
• Setting the blade lower limit stopper to the desired
depth on the scale plate allows rough depth of
cut. For accurate depth of cut, measure the actual
protrusion of saw blade below the tool base.
Quick stop button for 2 to 3 mm
depth of cut when using guide rail
(accessory)
► 1. Quick stop button
1
1
This tool has the quick stop button for 2 to 3 mm depth
of cut on the gear housing aside the rear handle when
using guide rail. This is used when avoiding splinter on
the workpiece in the cut. Make a pass of the 2 to 3 mm
first cut and then make another pass of usual cut.
To obtain the 2 to 3 mm depth of cut, push in the stop
button toward the saw blade. This is convenient for
avoiding splinter on the workpiece.
To release the depth of cut from this position for free
depth of cut, just pull the button back.
► 1. Quick stop button
Bevel cutting
1
► 1. Clamping screws 2. Tool base
Tilting to the right
► 1. Positive stopper
6 ENGLISH
1
1
1
2