Horizon Hobby Spektrum SR2010 Manuel D'utilisation page 7

2.4GHz Troubleshooting Guide
Problem
The system will
not connect
The receiver
goes into fail-
safe mode a
short distance
away from the
transmitter
The receiver
stops responding
during operation
Possible Cause
Your transmitter and
receiver are too close
together
You are around metal
objects
The receiver is not bound
to the active model
memory
Your transmitter was
accidentally put into bind
mode and is no longer
bound to your receiver
Check the receiver
antenna to be sure it is not
cut or damaged
Inadequate battery voltage
Loose or damaged wires
or connectors between
battery and receiver
Solution
Move transmitter 1 to 3
meters from receiver
Move to an area with less
metal
Check model selected and
ensure you are bound to
that model
Rebind your transmitter
and receiver
Replace the receiver or
contact Horizon Product
Support
Make sure your receiver
antenna is in an antenna
tube and is above the
vehicle
Charge or replace the
receiver batteries.
Spektrum receivers require
at least 3.5V to operate
(We recommend using
a 6V receiver pack). An
inadequate power supply
can allow voltage to mo-
mentarily drop below 3.5V
and cause the receiver to
brown out and reconnect
Check the wires and
connection between the
battery and receiver. Repair
or replace wires and/or
connectors
EN