Horizon Hobby Spektrum SR2010 Manuel D'utilisation page 6

EN
powering the receiver with a separate receiver pack
powering the receiver with an ESC
Receiver
Binding Receiver to Transmitter
In order to operate, the receiver must be bound to the transmitter. Binding
is the process of programming the receiver to recognize the GUID (Globally
Unique Identifier) code of a single specific transmitter. When a receiver is
bound to a transmitter/model memory, the receiver will only respond to that
specific transmitter/model memory.
Binding
1. With the receiver off, insert the bind plug into the BIND port in the receiver.
2. Power the receiver through any port. If an ESC is being used, connect the
ESC lead to the throttle channel port. The orange LED will flash continuously,
indicating that the receiver is in bind mode.
3. W ith the throttle channel in the desired preset failsafe position (normally
neutral), put your transmitter in bind mode. Continue holding the failsafe
position until the binding process is complete.
4. T he bind process is complete when the orange LED on the receiver is solid.
5. R emove the bind plug from the receiver and store it in a convenient place.
Failure to remove the bind plug will result in the receiver entering bind mode
the next time you power on the receiver.
You must rebind the transmitter and receiver if you:
• change the servo reverse after binding.
• want to use the receiver with a different model memory.
• are using the receiver with a DSMR transmitter and you change the frame
rate in the transmitter.
Receiver
Battery
Steering Servo
Throttle Servo
Steering Servo
Battery
Electronic
Speed Control
To Motor