Pioneer BDP-330 Mode D'emploi page 54

Settings
8
Press ENTER to check the data on the USB
memory device.
Insert USB memory device containing
the software update file.
• The screen message is displayed while the USB
memory device is being checked.
• The player's software version and the version of the
update file stored on the USB memory device are
displayed. To update the player's software, select
"Start" then press ENTER.
Software update file is detected in the USB memory
device. Start update?
Current Ver. :
Update Ver. :
• An error message is displayed if the USB memory
device could not properly recognized or if no update
file was found on the USB memory device. Check the
file on the USB memory device, then reconnect the
USB memory device properly.
Software update file is not detected in the USB memory device.
Confirm that you have transferred the file
to the USB memory device and retry software update.
Confirm that you have inserted the USB memory device
into the correct device.
54
OK
**1234567
**2345678
Yes
No
OK
9
Press ENTER to update the software.
• The screen becomes dark for several seconds. Wait
until the update screen appears. Do not unplug the
power cord.
The picture will temporarily go dark until
the software update display appears.
Wait several minutes and do not unplug the AC cord.
Now updating
Do not unplug AC cord.
*
Update Version
10
Check on the screen that updating has been
completed properly.
• If updating fails, check the file on the USB memory
device, then start over from step 1.
11
Press  STANDBY/ON to turn the power off.
12
Disconnect the USB memory device.
OK
**2345678
30%