Accessories - Scheppach DM460T Traduction Du Manuel D'origine

Maintenance
• Overhauls, maintenance work, cleaning, as well as the
elimination of any malfunctions must only be undertak-
en after turning off the motor.
• All protective and safety equipment must be reinstalled
immediately upon completion of any repair or mainte-
nance work.
• Clean and lightly oil the spindle thread of the tool holder
when changing tools.
• When possible, the tail stock sleeve should be removed
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
• Check the eccentric clamp of the tailstock as well as the
tool holder and adjust if necessary. In addition, tighten
the hex nut under the bracket.
• Check the drive belt and replace when necessary.
Problem
a)
Motor doesn't start
b)
c)
Work piece flatters while a)
working
b)
c)
Tool rest or tailstock Setting the eccentric clamping
cannot be clamped
14 english
Trouble shooting
Possible Cause
No electricity
Defective switch, condenser
Defective extension cord
Working piece becomes loose
while working
Work piece is not properly centered
Rotational speed is too high

Accessories

Article
Turning lathe extension
Additional tools 5er set
Additional tools 6er set
Screw chuck
Socket chuck Ø 30 mm
Socket chuck Ø 40 mm
Socket chuck Ø 60 mm
Driver plate Ø 80 mm
Three-jaw chuck Ø 100 mm
Four-jaw chuck Ø 125 mm
Drill chuck 3 – 16 mm cone mandrel MK-2
You can find other accessories in our current catalogue or
at www.scheppach.com.
Help
a) Check fuse
b) Have an electrician inspect unit
c) Unplug cord, inspect and replace, if
necessary
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Return the hexagonal nut at the bottom side
about ½ rotation with the socket spanner
Art. No.
4902301701
88002716
88002717
7400 7200
7400 8600
7400 7300
7400 8700
7400 8800
7400 8900
7400 7400
7400 7700