Genesis GDP805P Manuel D'utilisation page 5

Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0 18
2.1–3.4
18
3.5–5.0 18
5.1–7.0 18
7.1–12.0 18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr DrILL PrESSES
WArNING:
FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT SAFETY rULES. If
you use this tool unsafe or incorrectly, you can suffer serious personal injury!
Make sure the drill press is on a firm, level surface and properly secured
•
avoid injury from unexpected movement. firmly clamp or bolt the drill press to a support surface to prevent
slipping or sliding during the operation.
Unplug the drill press before making adjustments, repairs, maintenance or
•
storing.
Always switch off the drill press before unplugging it
•
re-plugging the tool into a power source.
Use recommended speeds for drill accessories and work piece material.
•
Allow the motor to come up to full
•
Wear eye protection. Do not wear gloves, necktie, or loose clothing.
•
Before starting the operation,
•
does not wobble or cause vibration.
Keep hands away from work area. Keep hands away from the bit.
•
Be sure drill bit or cutting tool is securely locked in the chuck.
•
Always clamp work piece or brace against column to prevent rotation.
•
use hand to hold the work piece while drilling.
Make sure the pulley housing cover is down and the chuck is installed
•
properly before engaging the power switch.
Keep bits clean and sharp.
•
Lock the switch off when leaving the drill press.
•
Before starting, be sure chuck key is removed from the chuck and the
•
motor head and table are locked.
Never start the dril
•
Adjust the table or depth stop to avoid drilling into the table.
•
When using a drill press vise, always fasten the vise to the table.
•
Do not operate in rain or in damp locations.
•
Grounding required.
•
50 Feet 75 Feet
18 18
18 18
18 16
16 14
14 12
12 10
10
DO NOT LET COMFOrT Or FAMILIArITY WITH PrODUCT (GAINED
jog the motor switch to make sure the drill bit or other cutting tool
Sharp bits minimize stalling.
l press when the bit or other cutting tool is in contact with the work piece.
SAVE THESE INSTRUCTIONS
100 Feet
18
16
14
12
10
10
8 8
speed before drilling to avoid binding or stalling.
150 Feet 200 Feet
16 16
14 14
12 12
12 10
8 8
8 6
6 6
to avoid accidental starting when
to
Never
5