Switching On The Light; Switching Off The Light - Harvia SENTIO Just Sauna Fin Instructions D'installation Et Mode D'emploi

Instructions for use for the user

10.8. Switching on the light

When the dimmer switch function is activated
When the dimmer function for the light is activated, the power for the light can
be set to any level between level 1 to level 8.
1. Press the light symbol
► The light LED
► The set power level is displayed for one second in the power level display
2. Press (press and hold) the light symbol
► While pressing and holding the symbol, the power level is increased by an
increment of one every second. Once power level 8 has been reached,
it starts again at power level 1.
3. Once the preferred power level has been reached, let go of the button.
► The light will operate at the power level selected.
► After a number of seconds, the power level display
When the dimmer switch function is deactivated
When the dimmer function for the light has been deactivated, you can only switch
the light on and off. The device will always operate at full power.
● Press the light symbol
► The light LED
► The light switches on.

10.9. Switching off the light

● Press the light symbol
► The light switches off.
► The light LED
The status of the light function is saved automatically. If the control unit
is switched off using the operating unit when the light is on, then the
sauna control unit saves this status and restores it the next time the unit
is switched on.
.
4
lights up.
5
.
4
lights up.
5
.
4
goes out.
5
and hold it down for several seconds.
4
3
p. 33/40
.
3
goes out.
EN