Length Measurement; Beep; Bluetooth - ADE M118000 Mode D'emploi

The value of the additional weight remains stored until the tare function or the scale is switched off.
Make sure that, for example, additional towels only come in contact with the
weighing surface. If a towel also comes in contact with the surface on which the
scale is placed, the weight readings will be incorrect.
To exit the tare function, briefly press the Tare key or switch off the scale.
7.6

Length measurement

NOTE Length measurement is only possible using models with mounted measurement
:
calipper. With other models, it is not possible to switch between weight and length
measurement.
The measuring function can also be upgraded. Please contact our customer
service.
To switch to length measurement, briefly press the L/W key. The display shows the current
measured length as well as the set unit.
Pull both measuring callipers completely apart.
Place the baby on the weighing surface. The exact position of the baby is irrelevant.
Place the two measuring callipers on the baby's head and feet. The display shows the measured
length value.
To exit the length measurement, briefly press the L/W key again.
7.7

Beep

NOTE: The beep tone is deactivated by default. If desired, you can activate the function.
Please ask for the extended instructions.
If activated, a beep sounds when ...
... the scale is overloaded.
... the scale is underloaded.
... a key is pressed.
7.8

Bluetooth

NOTE: The (optional) Bluetooth module is disabled at the factory.
Information on activating and setting up the Bluetooth interface as well as pairing
with other devices will only be announced once Bluetooth devices approved by
ADE are available.
Seite 30 von 112 M118000+M118000-01-210305-Rev002-UM-en