Starting/Stopping Engine; Transport Wheels - Jacobsen PGM 19 Manuel De L'opérateur Et De Sécurité

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5.4

STARTING/STOPPING ENGINE ______________________________________________

CAUTION: Always start and stop the engine
!
when the mower is on level ground. Keep feet
away from blade when starting engine.
Starting
1. Check oil level and fuel supply then open fuel valve
lever (H).
2. Move the choke lever (G) to the "CLOSED" position.
3. Move throttle control (B) to 1/2 throttle.
4. Set engine switch (E) to "ON".
5. Make certain the O.P.C. bail (D) is disengaged and
the parking brake (A) is engaged.
5.5

TRANSPORT WHEELS _____________________________________________________

!
WARNING
Always stop the engine and disengage the drive
levers before installing or removing the transport
wheels.
1. Push and hold the kickstand against the ground then
pull the mower handle back until the mower rests on
the stand (L).
2. To remove wheels, press retaining clip (J) away from
the hub and pull wheel off hub.
3. To install wheels, set brake, press retaining clip (J),
place wheel on hub and turn the wheel backwards
until studs on back of wheel line up with holes in
hub (K). Push wheel in and release clip.
4. Always disengage reel clutch lever (F), prior to
transporting the mower more than a few feet.
5. Push the mower forward off the kickstand, start the
engine and engage the O.P .C. bail (D).
6. When using a vehicle to transport the mower, apply
parking brake, stop engine and close fuel shut-off
valve. Chock or block the wheels.
6. Select desired position for reel clutch lever (F).
To cut - engage reel clutch (F).
To transport - disengage reel clutch (F).
7. Start the engine. Do not allow the cord to "snap"
back into the starter.
8. When engine starts, move choke lever (G) to the
"OPEN" position. Intermittent choking may be
required while engine is cold.
9. Allow engine to warm up gradually.
Stopping
1. To stop the engine, release the O.P .C. bail (D), and
set engine switch (E) to "OFF" position.
2. Engage parking brake.
!
!
WARNING
To prevent bodily injury or property damage,
never engage the reel clutch lever while the
engine is running or the O.P .C. bail is engaged.
J
OPERATION
!
K
L
Figure 5A
GB-9
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pgm 226227962280

Table des Matières