Conformity Certificates - Husqvarna FS 413 Manuel D'utilisation

American National Standards Institute : For units used in the United States, this machine has been
designed to comply with American National Standards Institute ANSI B.-000, "Safety Requirements
for the Use, Care and Protection of Abrasive Wheels". This standard can be purchased by contacting the
American National Standards Institute at the address shown below:
American National Standards Institute
25 West 43rd Street, 4th floor
New York, NY 00
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Apllication as relating to CARB standards. Under construction equipment, and in particular, as a con-
crete saw (Saws: concrete, masonry, cutoff), with engine power less than 9KW ( hp), CARB stan-
dards do not apply to this machine.
For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm
EUROPEAN UNION (EU): For units used in countries that are members of the European Union (EU),
this machine is designed to meet the EU directives as declared below.
DECLARATION OF CONFORMITY WITH THE "SAFETY OF MACHINERY" DIRECTIVE
conforms to the "SAFETY OF MACHINERY" directive (98//EC), the "LOW VOLTAGE EQUIPMENT" directive (//EEC), the
"ELECTROMAGNETIC COMPATIBILITY" (EMC) directive (89//EEC) in accordance with European standards EN 008/
and EN 0, and the "NOISE" directive (000//EEC) in accordance with European standard EN ISO .


CONFORMITY CERTIFICATES

HUSQVARNA CONSTRUCTION PRODUCTS
(Directive 98//EC) and the rules governing its transposition
MANUFACTURER
Husqvarna Construction Products North America
00 West 9th Street, Olathe, Kansas 0 USA
herewith declares that the machine(s) designed hereunder
98//EC), the "LOW VOLTAGE EQUIPMENT" directive (//EEC), the
Telephone: ..900
Fax: 212.398.0023
www.ansi.org
FS 413
), the "LOW VOLTAGE EQUIPMENT" directive (//EEC), the
26October2006
, Olathe, Kansas USA