Table Des Matières; Contents & Introduction - Husqvarna FS 413 Manuel D'utilisation

Contents
Section
Contents & Introduction................................................ 3
Symbols and Decals....................................................4-8
Safety Instructions.....................................................9-13
Parts Identification (What Is What).........................14-15
Assembly................................................................ 16-20
Operation ................................................................ 21-25
Maintenance & Lubrication ................................... 27-28
Trouble Shooting Guide............................................... 29
Wiring diagram............................................................. 30
Technical Data......................................................... 31-32
Accessories.................................................................. 33
Conformity Certificates.................................................34
Contact Information.......................................................35
Introduction
Thank you for purchasing your new machine from Husqvar-
na Construction Products. We have provided important
safety messages in this manual and on the machine.
Please read these messages carefully. A safety message
alerts you to potential hazards that could hurt you or oth-
ers. Each safety message is preceded by a symbol or the
) and one of two words, WARNING,
safety alert symbol (
or CAUTION.
These signal words mean:
WARNING
: Indicates a hazardous situation which,
if not avoided COULD result in death or serious injury.
CAUTION
: Indicates a hazardous situation, which,
if not avoided, COULD result in minor or moderate injury.
It may also be used to alert against unsafe practices.
Each message tells you what the hazard is, what can hap-
pen, and what you can do to avoid or reduce injury. Other
important messages are preceded by the word NOTICE.
NOTICE means:
NOTICE: Indicates a hazardous situation which, if not
avoided, could result in property damage. Your machine
or other property can be damaged if you don't follow this
instruction.
The safety labels should be periodically inspected and
cleaned by the user to maintain good legibility at a safe
viewing distance. If the label is worn, damaged, or is illeg-
ible, it should be replaced.
CONTENTS and INTRODUCTION
Page
Before operating machine, read and under-
stand this entire operation manual & engine
operation manual supplied with engine.
Be familiar with machine before operation!
Model Identification: Record machine serial number
plate information below for future reference
A. Model:______________________________________
B. Machine Serial No:____________________________
C. Year of Manufacture ___________________________
D. Mass of Machine (kg) __________________________
E. Engine Power (KW) ___________________________
F. Blade Diameter (mm) __________________________
G. Blade Speed (Revolutions / Minute) _______________
H. Electric Motor Voltage (If Equipped) _______________
I. Electric Motor Phase (If Equipped) _________________
J. Electric Motor Amperage (if Equipped) _____________
Other information not shown on machine serial plate:
Engine Serial No: _______________________________
See Engine Operation Manual for location.
Purchase Date:_________________________________
WARNING!