Checking Engine Oil; Changing Engine Oil - Husqvarna FS 413 Manuel D'utilisation

LUBRICATION:
Depth Control Grease Fitting (X): A grease
fitting allows lubrication of Blade Depth Control
(EE) screw. To access this grease fitting:
• Raise the Diamond Blade (H) to maximum height.
Open Tool Compartment (BB), temporarily remove opera-
tion manual bag.
• Grease fitting (X) is located near top of Blade Depth
Control (EE) Tube.
• Add Grease to the fitting. Raise and lower the machine
a few times to circulate the grease through the tube.
• Replace Operation Manual Bag, close Tool Compart-
ment (BB) door.
Engine Oil:

Checking Engine Oil:

Check that engine oil level is correct.
Engine Oil Dipstick (Z) is located on front of
engine. Refill engine oil in dipstick hole. When
checking oil level, Engine Oil Dipstick (Z) should
not be screwed in.
Because engine often operates at an angle, check oil
level with engine horizontal. Check frequently to ensure
that oil level never falls below lower mark on dipstick.
0W0 oil is recommended.
See engine operation manual for more information.

Changing Engine Oil:

• Turn machine Start Switch (DD) to OFF (0) position.
Let engine cool. Use Depth Control (EE) to tilt machine
slightly backwards.
• Reposition Oil Drain Hose (NN) to side of machine.
Set a suitable container, large enough to hold engine oil
capacity, beside machine to catch oil.
• Open end of Oil Drain Hose (NN), and let oil drain into
container. After oil is drained, replace Oil Drain Hose
(NN) end, tighten securely, return hose to original position.
• Fill engine with recomended quantity of oil - see engine
manual for details.
• Dispose of used oil in an environmentally safe manner.
MAINTENANCE & LUBRICATION