Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ORIGINAL OPERATING INSTRUCTIONS
TE 6-A Li cordless rotary hammer
It is essential that the operating
instructions are read before the
tool is operated for the first time.
Always keep these operating
instructions together with the tool.
Ensure that the operating instruc-
tions are with the tool when it is
given to other persons.
Operating controls
Chuck
Side handle with depth gauge
Selector switch for hammering action / rotary only
Forwards / reverse switch and transport lock
Control switch
Battery (accessory, not supplied with the tool)
Release buttons with additional function - activation
of charge status indicator
Charge status and fault indicator
Contents
General information
1. Signal words and their meaning
-WARNING-: The word WARNING is used to draw atten-
tion to a potentially dangerous situation which could
lead to severe personal injury or death.
-CAUTION-: Used to draw attention to a potentially
dangerous situation which could lead to minor person-
al injury or damage to the equipment or other property.
-NOTE-: Used to draw attention to an instruction or other
useful information.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071062 / 000 / 00
2. Pictograms
Warning signs
General
warning
Obligation signs
Wear eye
Wear a
protection
hard hat
Symbols
Read the
operating
instructions
before use
V
---
- - - = direct current
n
= no load speed
o
The numbers refer to the illustrations. The illustra-
tions can be found on the fold-out cover pages. Keep
these pages open while you read the operating instruc-
tions.
In these operating instructions, the TE 6-A Li with battery
Page
is referred to as "the tool".
1
Location of identification data on the power tool
1
The type designation can be found on the type identifi-
2
cation plate and the serial number on the side of the
3
motor housing. Make a note of this data in your oper-
ating instructions and always refer to it when making an
5
enquiry to your Hilti representative or service depart-
5
ment.
6
Type:
7
7
Serial no.:
8
Description
The TE 6-A Li is a cordless, battery-powered, rotary ham-
mer drill with pneumatic hammering mechanism designed
for professional use.
The following conditions must always be observed
when the tool is in use:
- The tool is for hand-held use only.
- Do not use the tool in places where the surrounding
conditions may present a risk of explosion.
Warning:
Warning:
electricity
substances
Wear ear
Wear
protection
protective
breathing
gloves
protection
Return
Do not dispose
waste material
of batteries
for recycling
with general
min
-1
= revolutions per minute
j
= hammer drilling
= rotation only
en
caustic
Wear
refuse
1
Publicité
Chapitres
Table des Matières
