Error Messages - Sony RM-450A Mode D'emploi

Error Messages

Error No.
1 The recorder cannot be controlled when the unit is to perform the automatic operation
including the pinch on delay detection (LEARN) function.
2 The recorder is in the STANDBY OFF mode when the unit is to perform the automatic
operation including the LEARN function.
3 The tape inserted in the recorder is in the record inhibit mode.
4 The edit mode is not selected yet when the unit is to perform the automatic edit.
5 The OUT point is ahead of the IN point.
6 The video IN point is not entered when the unit is to perform the automatic split edit.
7 The unit cannot find the IN or OUT point by the GO TO key operation, or the tape is too
short to preroll.
8 The servo-mechanisms cannot be locked at the IN point. However, this message is not
displayed when bit 5 of the right DIP switches on the inside panel is set to ON.
9 The unit failed to synchronize the player and the recorder when bit 4 of the right DIP
switches is set to ON.
10 The unit cannot detect what type of VTR is connected when the unit is to perform the
automatic edit. Please set the edit timing manually.
11 The operation for the automatic split editing is made although you selected the
assemble edit mode.
12 The connected VTR is operated manually while the unit is performing the automatic
edit.
13 The player's operation cannot be detected when the LEARN button is pressed.
14 The player is in the STANDBY OFF mode when the LEARN button is pressed.
This unit displays an error number on the time counter to indicate that an
error has occurred.
Meaning
31