Operator Safety Information - Clarke Ultra Speed 01540A Manuel De L'utilisateur

DANGER :
Severe bodily injury or death can occur to you or other personnel if the DANGER statements found on this machine or in this Owner's
Manual are ignored or are not adhered to. Read and observe all DANGER statements found in this Owner's Manual and on your
machine.
WARNING:
Injury can occur to you or to other personnel if the WARNING statements found on your machine or in this Owner's Manual are
ignored or are not adhered to. Read and observe all WARNING statements found in this Owner's Manual and on your machine.
CAUTION :
Damage can occur to the machine or to other property if the CAUTION statements found on your machine or in this Owner's Manual
are ignored or are not adhered to. Read and observe all CAUTION statements found in this Owner's Manual and on your machine.
DANGER:
Failure to read the Owner's Manual prior to operating or attempting any service or maintenance procedure to your machine could re-
sult in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in
the operation of this machine before using it. If you or your operator(s) cannot read English, have this manual explained fully before
attempting to operate this machine.
To reduce the risk of fi re, use only commercially available fl oor cleaners and waxes intended for machine application.
Machines can cause an explosion when operated near fl ammable materials and vapors. Do not use this machine with or near fuels,
grain dust, solvents, thinners, or other fl ammable materials. Precautions should be taken during the use of this machine to prevent
formation of a combustible mixture of fl yings and air. Use this machine only in a well ventilated area.
Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate this machine
until it is completely assembled. Inspect the machine carefully before operation.
Electrocution could occur if maintenance and repairs are performed on a unit that is not disconnected from the power source. Discon-
nect the power supply before attempting any maintenance or service. Always remove the electrical plug from the electrical outlet
before changing the pad and before leaving the machine.
Using a machine with a damaged power cord could result in an electrocution. Do not use the machine if the power cord is damaged.
Do not use the electrical cord to move the machine.
WARNING:
Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be
performed by authorized personnel only. Keep all fasteners tight. Keep adjustments according to specifi cations.
Electrical components of this machine can "short-out" if exposed to water or moisture. Keep the electrical components of the machine
dry. Wipe the machine down after each use. For storage, keep the machine in a dry building.
Always use a three-wire electrical system connected to the electrical ground. For maximum protection against electric shock, use a
circuit that is protected by a ground fault interrupter. Consult your electrical contractor.
To prevent damage to the power cord, do not let the pad, pad driver or wheels touch the power cord when the machine is running.
Always lift the cord over the machine. Do not pull the power cord to move the machine.
Any alterations or modifi cations of this machine could result in damage to the machine or injury to the operator or other bystanders.
Alterations or modifi cations not authorized by the manufacturer voids any and all warranties and liabilities.
Clarke
®
Operator's Manual (EN) - Ultra Speed Burnisher FORM NO. 71280A - 3 -