Publicité
Les langues disponibles
Les langues disponibles
Modification for Positive Ground Operation of Charger
For use with a vehicle with a positive ground battery, the connection to the charger plug must be
reversed.
The vehicle charger is not user serviceable. Have this modification made at your nearest qualified
D
WALT certified service center.
E
OPERATION
Chargers
Be sure to read all safety instructions before using your charger. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
Charging Procedure (Fig. 2)
WARNING: Do not charge batteries in explosive atmospheres. Ignition may occur.
1. Unwrap cord and plug in the charger.
2. Insert the battery pack into the charger, as shown in Figure 2, making sure the pack is fully
seated in the charger.
3. The indicator light will start to blink. Refer to Indicator Light Operation below.
4. In about 45 minutes, for a standard battery, the indicator light will stop blinking and remain
continuously on. Fast charging is complete and your battery pack is ready for use.
5. The indicator light will remain on for an additional 6 hours while the charger maintains your
battery pack in a fully charged condition.
6. After 6 hours, the charger will shut off automatically to reduce the amount of energy drained
from the vehicle's battery.
7. The indicator light may stay on momentarily after the battery pack is removed from the charger.
ALWAYS wait for the indicator light to go out before inserting another pack.
NOTICE: To prevent excessive discharge of the vehicle battery, do not charge more than two
battery packs without operating the vehicle.
Indicator Light Operation
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
x
PROBLEM PACK OR CHARGER
PROBLEM POWERLINE
Charge Indicators
This charger is designed to detect certain problems that can arise. Problems are indicated by the red
light flashing at a fast rate. If this occurs, re-insert the battery pack into the charger. If the problem
persists, try a different battery pack to determine if the charger is working properly. If the new pack
charges correctly, then the original pack is defective and should be returned to a service center or
other collection site for recycling. If the new battery pack elicits the same trouble indication as the
original, have the charger and the battery pack tested at an authorized service center.
HOT/COLD DELAY
This charger has a hot/cold delay feature: when the charger detects a battery that is hot, it
automatically starts a delay, suspending charging until the battery has cooled. After the battery
has cooled, the charger automatically switches to the pack charging mode. This feature ensures
maximum battery life. The red light flashes long, then short while in the hot/cold delay mode.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the charge indicator showing pack
charged.
WEAK BATTERY PACKS: Weak batteries will continue to function but should not be expected
to perform as much work.
FAULTY BATTERY PACKS: This charger will not charge a faulty battery pack. The charger will
indicate faulty battery pack by refusing to light or by displaying problem pack or charger.
NOTE: This could also mean a problem with a charger.
PROBLEM POWER LINE
Some chargers have a Problem Powerline indicator. When the charger is used with some portable
power sources such as generators or sources that convert DC to AC, the charger may temporarily
suspend operation, flashing the red light with two fast blinks followed by a pause. This indicates the
power source is out of limits.
Important Charging Notes
1. To prevent excessive discharge of the vehicle battery, do not charge more than two
battery packs without operating the vehicle.
2. Disconnect charger from cigarette lighter socket when not in use to prevent vehicle
battery from discharging.
3. Longest life and best performance can be obtained if the battery pack is charged when the air
temperature is between 65°F and 75°F (18° – 24°C). DO NOT charge the battery pack in an
air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will
prevent serious damage to the battery pack.
4. The charger and battery pack may become warm to the touch while charging. This is a normal
condition, and does not indicate a problem. To facilitate the cooling of the battery pack after
use, avoid placing the charger or battery pack in a warm environment such as in a metal shed
or an uninsulated trailer.
5. A cold battery pack will charge at about half the rate of a warm battery pack. The battery
pack will charge at that slower rate throughout the entire charging cycle and will not return to
maximum charge rate even if the battery pack warms.
6. If the battery pack does not charge properly:
a. Ensure the cigarette lighter operates when pushed in the socket.
b. Ensure the cigarette lighter operates when the vehicle's ignition switch is in the accessory
position.
7. The battery pack should be recharged when it fails to produce sufficient power on jobs which
were easily done previously. DO NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack whenever you desire with no
adverse effect on the battery pack.
8. Foreign materials of a conductive nature such as, but not limited to, grinding dust, metal chips,
steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery pack in the
cavity. Unplug the charger before attempting to clean.
9. Do not freeze or immerse the charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside the charger. Electric shock may
result.
WARNING: Burn hazard. Do not submerge the battery pack in any liquid or allow any liquid to
enter the battery pack. Never attempt to open the battery pack for any reason. If the plastic housing
of the battery pack breaks or cracks, return to a service center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry, away from direct sunlight and excess heat
or cold.
2. For long storage, it is recommended to store a fully charged battery pack in a cool dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will
need to be recharged before use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
MAINTENANCE
Cleaning
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the cigarette lighter receptacle before
cleaning. Dirt and grease may be removed from the exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any cleaning solutions.
FIG. 1
Repairs
The charger and battery pack are not serviceable. There are no serviceable parts inside the charger
or battery pack.
READ ALL OF THE INSTRUCTIONS IN THE IMPORTANT SAFETY INSTRUCTIONS AND
IMPORTANT SAFETY INSTRUCTIONS FOR ALL BATTERY PACKS SECTIONS OF THIS
MANUAL BEFORE ATTEMPTING TO CHARGE THE BATTERY PACK FOR YOUR TOOL.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be
performed by certified service centers or other qualified service organizations, always using identical
replacement parts.
Three Year Limited Warranty
D
WALT will repair, without charge, any defects due to faulty materials or workmanship for three
E
years from the date of purchase. This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair information, visit www.D
com or call 1-800-4-D
WALT (1-800-433-9258). This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by others. This warranty gives you
specific legal rights and you may have other rights which vary in certain states or provinces.
In addition to the warranty, D
WALT tools are covered by our:
E
1 YEAR FREE SERVICE
D
WALT will maintain the tool and replace worn parts caused by normal use, for free, any time
E
during the first year after purchase.
2 YEARS FREE SERVICE ON D
DC9071, DC9091, DC9096, DC9280, DC9360, DC9180, DCB120 and DCB201
3 YEARS FREE SERVICE ON D
D
WALT BATTERY PACKS
E
Product warranty voided if the battery pack is tampered with in any way. D
for any injury caused by tampering and may prosecute warranty fraud to the fullest extent permitted
by law.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your D
Nailer for any reason, you can return it within 90 days from the date of purchase with a receipt for
a full refund – no questions asked.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products
sold in Latin America, see country specific warranty information contained in the packaging, call the
local company or see website for warranty information.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing,
call 1-800-4-D
WALT (1-800-433-9258) for a free replacement.
E
Définitions : lignes directrices en
matière de sécurité
Les définitions ci-dessous décrivent le niveau de danger pour chaque mot-
indicateur employé. Lire le mode d'emploi et porter une attention particulière à ces
symboles.
DANGER : indique une situation dangereuse imminente qui, si elle n'est pas
évitée, entraînera la mort ou des blessures graves.
AVERTISSEMENT : indique une situation potentiellement dangereuse qui, si elle
n'est pas évitée, pourrait entraîner la mort ou des blessures graves.
ATTENTION : indique une situation potentiellement dangereuse qui, si elle n'est
pas évitée, pourrait entraîner des blessures légères ou modérées.
AVIS : indique une pratique ne posant aucun risque de dommages corporels
mais qui par contre, si rien n'est fait pour l'éviter, pourrait poser des risques de
dommages matériels.
POUR TOUTE QUESTION OU TOUT COMMENTAIRE RELATIF À CET OUTIL OU À PROPOS DE
TOUT AUTRE OUTIL D
WALT, COMPOSER SANS FRAIS LE : 1-800-4-D
E
9258).
AVERTISSEMENT ! Lire et comprendre toutes les directives. Le
non-respect des directives suivantes comporte des risques de choc
électrique, d'incendie et/ou de blessure grave.
CONSERVER CES DIRECTIVES
DIRECTIVES IMPORTANTES DE SÉCURITÉ
1. CONSERVER CES DIRECTIVES : ce manuel contient des consignes de sécurité et
d'utilisation importantes relatives au chargeur de piles pour véhicule D
2. Avant d'utiliser le chargeur, lire toute consigne et tout avertissement apposés sur le chargeur,
le bloc-piles et le produit utilisant le bloc-piles.
3.
AVERTISSEMENT : risques de chocs électriques. Ne laisser aucun liquide pénétrer dans le
chargeur, des chocs électriques pourraient en résulter.
4.
ATTENTION : risques de brûlure. Pour réduire tout risque de dommages corporels, ne
recharger que des blocs-piles rechargeables D
exploser et causer des dommages corporels et matériels.
5. Protéger le chargeur de la pluie ou de la neige.
6. L'utilisation de tout accessoire non recommandé ou non vendu par le fabricant du chargeur de
pile comporte des risques d'incendie, de choc électrique ou d'électrocution.
7. Pour réduire tout risque d'endommager la connexion à l'allume-cigarettes ou au cordon
d'alimentation, tirer sur la connexion à l'allume-cigarettes plutôt que sur le cordon pour
débrancher le chargeur.
8. Ne pas utiliser dans un environnement marin (eau de mer). L'eau de mer est corrosive et
pourrait endommager le chargeur.
9. S'assurer que le cordon est protégé de manière à ce que personne ne marche ni ne trébuche
dessus ou à ce qu'il soit ni endommagé ni soumis à aucune tension.
FIG. 2
WALT BATTERY PACKS
E
WALT BATTERY PACKS
E
DCB200
WALT is not responsible
E
WALT Power Tool, Laser, or
E
WALT (1-800-433-
E
WALT DCB119.
E
WALT. Tout autre type de piles pourrait
E
WALT.
E
Publicité
