General Instructions - Lamborghini Caloreclima 310 PM/M-E Notice D'installation Et D'entretien

GENERAL INSTRUCTIONS

This booklet constitutes an integral and essential part of the product and should be supplied to the installer.
Read carefully the instructions contained in this booklet as they provide important directions regarding the
safety of installation, use and maintenance.
Preserve this booklet with care for any further consultation. The installation of the burner must be carried out in
compliance with current regulations, according to the instructions of the manufacturer and by qualified person-
nel. An incorrect installation can cause injury or damage to persons, animals and objects, for which the manu-
facturer cannot be held responsible.
This appliance should be destined only for the use for which it has been expressly envisaged.
Any other use is to be considered improper and therefore dangerous.
The manufacturer cannot be considered responsible for any damages caused from improper, erroneous or
unreasonable use.
Before carrying out any cleaning or maintenance operation, disconnect the appliance from the power supply, by
using the main system switch or through the appropriate interception devices.
In case of failure and/or malfunctioning, switch off the equipment and refrain from trying any repair or
direct intervention.
Call in qualified personnel only.
Any repair must be carried out by a servicing centre authorised by the manufacturing firm, one using original
replacements exclusively.
Non-observance of the above could compromise the safety of the appliance.
In order to guarantee the efficiency of the appliance and its proper operation it is indispensible to keep to the
manufacturer's directions, by ensuring the periodical servicing of the appliance is carried out by professionally
qualified personnel.
As soon as one decides not to use the appliance further, one should take care to render innocuous those parts
liable to be potential sources of danger.
The transformation from a gas (natural gas or liquid gas) to a gas of another group must be made exclusively by
qualified personnel.
Before starting up the burner for the first time ask qualified personnel to check:
a) that the data on the information plate corresponds to that required by the gas, and electrical supply net-
works;
b) that the calibration of the burner is compatible with the boiler output;
c) that the comburent air flow and the fumes evacuation take place properly in accordance with the regula-
tions in force.
d) that correct aeration and maintenance are possible.
After each reopening of the gas cock wait a few minutes before restarting the burner.
Before carrying out whatever intervention which foresees the dismantling of the burner or the opening of
any of the accesses for inspection, disconnect the electrical current and close off the gas cocks.
Do not deposit containers of inflammable substances in the location where the burner is situated.
On noticing the smell of gas do not touch any electrical switch. Open all doors and windows. Shut off the
gas cocks. Call qualified personnel.
The room where the burner is located must have the openings required by local regulations in force. Should
you have any doubts as to the circulation of the air in the room, then you should first measure the CO
with the burner working at its maximum delivery and with the room ventilated solely by means of the openings
that feed air to the burner; a second CO
The CO figure should not vary very much from the first to the second reading. Should there be more than one
2
burner and one fan in the same room,then this test must be carried out with all the appliances working at the
same time.
measurment should then be taken with the door open.
2
27
M U
figure
2
UK