Fitting The Hose - Zodiac X7 Quattro Notice De Montage Et D'utilisation

Notice X7 ANG 2010.qxd 12/07/10
Figure 1
Figure 2
Figure 3
17.5 cm
shorter hose
section
Figure 4
incorrect
10:32 Page 5
1 6

2 / Fitting the hose

The hose for your X7 Quattro is composed of 12 x 1 m sections,
plus a smaller section of 17.5 cm.
Greatest
distance
Lock latch
•
Once you have calculated the total length, assemble your
hose by inserting the 1 m sections into each other, male end
connected to female end. In order the join them correctly,
give the hose a quarter turn so as to position the latch in
the notch
•
Connect the shorter section (17.5 cm) to the cleaner
(Figure
•
Fit the assembled hose onto the smaller 17.5 cm hose section.
•
A hose weight is supplied, to be used if the X7 Quattro tends to
lift off the bottom of the pool
approximately 2 m from the cleaner
the disc is perfectly flat on the bottom of the pool when the robot
is operating.
correct
incorrect
•
The ideal hose length for your pool corresponds
to one 1 m hose section plus the greatest distance
between the plug in point (suction point or skimmer)
and the furthest point in your pool
Ex: if the greatest distance between the suction point
or skimmer and the furthest point equals 10 metres,
you will need 11 sections of 1 metre.
(Figure 2).
3).
(Figure
Figure 5
(Figure 1).
4). Adjust the hose weight
(Figure 5) and ensure that
2 m