Emptying The Boiler; Troubleshooting - Ferroli AQUA1 PLUS Manuel D'utilisation

Manuale utente
diameter, cavity, reduction of the length) carry out
the replacement of the anode taking care of
replacing the sealing gasket as well, both in case
of verification and replacement (Fig. 8).
At the end of the verification or the replacement
of the anode, it is recommended to reset the
water connection (previously removed to allow
the emptying of the boiler) filling and pressurizing
the boiler in order to verify that no water losses are
incurred in the area where the maintenance
intervention has been carried out.
At the end of the verifications, reassemble the
product following backwards
reported in this paragraph.
The operation of periodical verification or
replacement of the magnesium anode is
an opportunity to carry on other little
maintenance operations
ensure the maximum efficiency of the
product.
In particular, once removed the aesthetic
components the evaporator can be
accurately cleaned, using a brush with
soft bristles, taking care not to deform the
aluminum fins. It is also possible to verify
that there are no dirt deposits in the
condensate drain pipe.
These little precautions ensure the total
efficiency of
consequent energy saving.
the indications
in order to
the product with a
Mg Anode
Anode gasket
¾"
Fig. 8 – Removal of the anode
4.7

Emptying the boiler

It is advisable to drain the water from inside the
boiler if the boiler is idle for a certain period of time,
especially in low temperatures.
As for the equipment in question, it is sufficient to
disconnect the water supply input connection).
Alternatively, during the system installation stage, it
is advisable to install a drain tapwith a hose-
holding connection.
N.B.: It is important to empty the system
in case of low temperatures in order to
avoid the water freezing.
5

TROUBLESHOOTING

In case of problems of equipment performance,
without the occurrence of any of the alarms or
errors described in the relative paragraphs, it is
advisable to check to see if the problem can
be easily solved by checking the possible
solutions specified in the table below prior to
seeking technical assistance.
Problem Possible causes
pag. 13 / 14