Baier BFS 7936 Traduction Du Mode D'emploi Original page 17

Imprint
Version V01 / 2019-04
Copyright:
Maschinenfabrik
OTTO BAIER GmbH
Heckenwiesen 26
71679 Asperg
Germany
It is prohibited to forward or reproduce this docu-
ment or to exploit and disclose its contents, unless
expressly permitted. Any infringements will result in
liability to pay compensation for damages. All rights
reserved in case of patent, utility model or design
registration.
This instruction manual has been prepared with
the greatest possible care. Nonetheless, OTTO
BAIER GmbH does not accept any liability
whatsoever for possible errors in this instruction
manual and their consequences. Equally, no liability
whatsoever is accepted for direct or consequential
damage or losses resulting from improper use of the
machine.
The national health and safety regulations and the
requirements of this instruction manual are to be
observed when using the machine.
All product names and brand names used are the
property of the holder and are not explicitly marked
as such.
Subject to change without notice.
Contents
1 About this Instruction Manual ............ 18
1.1 Important information ............................. 18
1.2 Symbols used in the instruction manual 18
2 Safety Instructions .............................. 18
2.1 Operating personnel requirements ........ 18
2.2 Workplace safety .................................... 19
2.3 Electrical safety ...................................... 19
2.4 Safety of people ...................................... 19
2.5 Use and handling of the walk- behind
system ..................................................... 20
2.5.1 Service / Maintenance / Repair .............. 20
2.5.2 Explanation of the pictograms on the
walk-behind system ................................ 20
3 Technical Characteristics ................... 21
3.1 Walk-behind system technical
specifications .......................................... 21
3.2 EU Declaration of Conformity ................ 21
3.3 Controls .................................................. 21
3.4 Intended use ........................................... 21
4 Before Starting Work ........................... 22
5 Adjusting the walk­behind system
to the Baier diamond channel
cutter to be mounted ........................... 22
5.1 Modifying the walk-behind system ......... 22
6 Mounting a Baier diamond channel
cutter onto the walk­behind system .. 23
6.1 Preparing the diamond channel cutter
for mounting onto the walk-behind
system ..................................................... 23
6.2 Preparing the walk-behind system for
holding the diamond channel cutter ....... 23
6.3 Mounting the walk-behind system on
the diamond channel cutter .................... 23
7 Operation and Control ......................... 24
7.1 Adjusting the walk-behind system to
the operator ............................................ 24
7.1.1 Adjusting the working height .................. 24
7.1.2 Adjusting the bottom handle .................. 24
7.1.3 Adjusting the guide indicator .................. 24
7.2 Switch on the diamond cutter and cut .... 24
7.3 Finish cutting process ............................ 25
8 Cleaning ................................................. 25
9 Maintenance .......................................... 25
10 Tools and Accessories ........................ 25
11 Disposal ................................................. 25
12 Scope of Supply ................................... 26
13 Warranty ................................................ 27
| 17 |