Maintenance And Service; Maintenance And Cleaning - BRICK MPV2200-75 Traduction Des Instructions D'origine

For low temperatures, the machine reaches the full
impact rate only after a certain time.
This start-up time can be shortened by striking the
chisel in the machine against the floor one time.
Operating Instructions
For the highest possible impact damping, work only
with moderate pressure.
Sharpening Chisels
Good results are only achieved with sharp chisels;
therefore, sharpen the chiselling tools in good time.
This ensures a long service life of the tools and
good working performance.
Re-sharpening
Sharpen chiselling tools using grinding wheels (e. g.
ceramic bonded corundum wheel) with a steady
supply of water. Reference values are shown in the
figure.
Take care that no annealing coloration appears on
the cutting edges; this impairs the hardness of the
chiselling tools.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
When the carbon brushes wear below acceptable
service tolerances, the machine will automatically
cut out. The machine must be sent to customer
service for maintenance (for address, see the
"Service and Customer Assistance" section.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
BRICK power tools.
17