Siemens VS07 Série Notice D'utilisation page 15

en
Fold out picture pages.
Before using for the first time
1*
Figure
Push the handle onto the flexible tube
and until it engages.
Setting up
Figure
2
a) Insert the flexible hose connector into
the opening on the vacuum cleaner
until it engages.
b) To remove the flexible hose, press the
release button and pull out the hose.
Figure
3*
a) Push the handle into the telescopic
tube.
To release the connection, turn the
handle slightly and pull out of the
pipe.
b) Push the handle into the telescopic
tube until it engages.
To release the connection, squeeze
the collar sleeve and pull the handle
out.
Figure
4*
a) Put the telescopic tube into the
connecting piece of the floor tool.
To release the connection, turn the
pipe slightly and pull out of the floor
tool.
b) Push the telescopic tube into the
connecting piece of the floor tool until
it engages.
Press on the locking collar and pull
out the telescopic tube to disconnect.
* Depending on equipment
Figure
5*
Unlock the telescopic tube by moving
the release button in the direction of
the arrows and then set it to the
required length.
Figure
6
Take the mains plug, pull the mains
cable to the required length and insert
the plug into a wall socket.
Figure
7
To switch your vacuum cleaner on,
press the On/Off button in direction of
arrow.
Figure
8
Use the slide control to adjust the
suction to the required level.
Vacuuming
Figure
9
Adjusting the floor tool:
For cleaning rugs
and carpets
For cleaning
hard floors
Turbo brush
If your appliance is equipped with a
turbo brush, please read the notes on
use and maintenance in the enclosed
instructions.
Polymatic hard floor brush
If your vacuum cleaner is equipped with
a Polymatic hard floor brush, please
refer to the notes on use and mainten-
ance in the operating instructions provi-
ded.
=>
=>
11