Makita HR3011FC Manuel D'instruction page 9

Install the dust cup set with the spacer on the tool so
that the symbol on the dust cup is aligned with the
groove in the tool.
► 1. symbol 2. Groove
To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
1
2
► 1. Bit 2. Chuck cover
Hold the spacer and pull it out.
For Model HR3012FC
Before installing the dust cup set, remove the bit from
the tool if installed.
Install the dust cup set on the tool so that the
bol on the dust cup is aligned with the groove in the tool.
1 1 1
2
► 1. symbol 2. Groove
To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
1
2
► 1. Bit 2. Chuck cover
Hold the root of dust cup and pull it out.
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
9 ENGLISH
sym-
1 1 1
2