Comfee CDWPB1215P-W Manuel D'instructions page 38

Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Program button
for more than 5 seconds to enter the water softener setting mode.
3. Press the Program button again to select the proper setting according to your local
water hardness, the setting will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
WATER HARDNESS
German German
French French British British
dH dH fH fH Clarke Clarke
0-5 0-9 0-6
6-11 10-20 7-14
12-17 21-30 15-21
18-22 31-40 22-28
23-34 41-60 29-42
35-55 61-98 43-69
° °
1 dH=1.25 Clarke=1.78 fH=0.178mmol/l
The factory setting: H3
1)
Every cycle with a regeneration operation consumes additional 2.0 litres of water,
the energy consumption increases by 0.02 kWh and the program extents by 4
minutes.
Water softner level
Mmol/l Mmol/l
0-0.94 H1- Cloud wash
H2-Rapid Light bright
1.0-2.0
2.1-3.0 H3-Rapid, Cloud wash
3.1-4.0 H4-1 hour Light bright
H5-1 hour, Cloud wash
4.1-6.0
6.1-9.8 H6-1 hour, Rapid Light bright
°
Regeneration
No regeneration
Light bright
Light bright
Light bright
7 7
occurs every
Salt consumption
X program
(gram/cycle)
1)
sequence
10
5
3
2
1
0
9
12
20
30
60