Electrical Connection (U.k. Only) - De'Longhi ROTO FRY Mode D'emploi

ElEctrical connEction (U.K. only)

A) If your appliance comes fitted with a plug, it will incorporate
a 13 Amp fuse. If it does not fit your socket, the plug should
be cut off from the mains lead, and on appropriate plug fitted,
as below. warning: Very carefully dispose of the cut off plug
after removing the fuse: do not insert in a 13 Amp socket el-
sewhere in the house as this could cause a shock hazard. With
alternative plugs not incorporating a fuse, the circuit must
be protected by a 15 Amp fuse. If the plug is a moulded-on
type, the fuse cover must be re-fitted when changing the fuse
using a 13 Amp Asta approved fuse to BS 1362. In the event
of losing the fuse cover, the plug must NOT be used until a
replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse
cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the
instructins provided below:
warning - this appliance must be earthed
important
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead may not correspond
with the coloured markings identifying the terminals in your plug,
proceed as follows:
The green and yellow wire must be connected to the terminal in
the plug marked with the letter E or the earth symbol
loured green or green and yellow.
The blue wire must be connected to the terminal marked with the
letter N or coloured black.
The brown wire must be connected to the terminal marked with
the letter L or coloured red.
or co-
3