Connecting.to.a.walkman - Sony Walkman WLA-NWB1 Mode D'emploi

Connecting to a Walkman
Connect this unit to the WM-PORT of a Walkman firmly.
Power button
To turn on this unit
Connect this unit to the Walkman, then the power of this unit will
turn on automatically. If the power of this unit is off while the unit is
connected to the Walkman, press and hold the unit's power button
for about 2 seconds to turn it on. When this unit turns on, the
indicator flashes twice.
To turn off this unit
To turn off this unit, press and hold this unit's power button for
about 2 seconds. The indicator flashes once and this unit turns off.
 T ip
Maximum Communication time or standby time may vary depending on your
Walkman. For details, visit the following web sites:
USA: http://www.sony.com/walkmansupport/
Canada: http://www.sony.ca/ElectronicsSupport/
Europe: http://www.sonydigital-link.com/DNA/
China: http://service.sony.com.cn/KB/
Taiwan: http://www.twsupport.css.ap.sony.com/
Korea: http://scs.sony.co.kr/walkman/
Other countries or areas: http://www.css.ap.sony.com/
Notes
 To listen to music from the headphone jack of the Walkman, disconnect this unit
from the Walkman.
 While this unit is turned on, it consumes power from the Walkman. We
recommend turning off this unit when not using the Bluetooth function.
 If you turn off this unit while the Walkman is playing back, playback will stop.
 There is no need to charge this unit as it will receive power from the connected
Walkman. It is recommended to check the Walkman's remaining battery before using.
 Depending on the Walkman model, you may not be able to connect the
headphone to it when this unit is connected to the Walkman.
WM-PORT (22 pin)

GB