Distorted Sound - Sony Walkman WLA-NWB1 Mode D'emploi

Symptom

Distorted sound

Sound break,
noise or playback
speed change
Pairing cannot be
established.
Bluetooth
connection cannot
be established
with a device that
has been "paired"
before.
Cause / Remedy
 Turn down the volume of the Bluetooth receiving
device to the point where the sound is no longer
distorted. For details on volume adjustment, refer
to the operating instructions supplied with the
Bluetooth receiving device.
 Set the MODE switch to MODE 2.
 If a device that generates electromagnetic radiation,
such as a wireless LAN, other Bluetooth device(s),
or a microwave oven is nearby, move away from
such sources.
 Remove any obstacle between this unit and other
Bluetooth device or move away from the obstacle.
 Locate this unit and other Bluetooth device(s) as
near as possible.
 Re-position or re-orient this unit.
 Re-position or re-orient other Bluetooth device.
 Locate this unit and other Bluetooth device(s) as
near as possible.
 Check if you input correct passcode (page 8).
 This unit tries to connect with either of the last two
devices recognized before.
If you want to establish the Bluetooth connection
with a Bluetooth device that is paired before either
of the last two devices recognized, turn on the
unit and establish the Bluetooth connection from
the Bluetooth device while the unit's indicator
flashes slowly from 10 to 13 times (for about 10-13
seconds). If the problem persists, pair the devices
again.
 Pairing information may be deleted. Pair the device
again.
17
GB