Jøtul F 105 R Manuel D'installation page 16

ENGLISH
Fig. 11
A
12. Lift the stove from the pallet.
13. Set up the stove and adjust to a horizontal position with the
4 height adjustment screws. Use the hex key placed in the
bag of screws. Mark on the wall if there has to be a rear
outlet for flue pipe and external air supply. NB: Take into
account the height of the floor plate.
Approval label
Fig. 12
A
14. Take the approval label (A) out of the burn chamber and
fasten it with the screw (B), as displayed. Tighten the screw
with a cap wrench. NB: Do not cut off the wire used for
fastening the label.
16
A
A
B
External air supply through the floor
Fig. 13
A
1. Fasten the adapter (A) to the bottom side of the burn
chamber using the accompanying screws (B) (pre-
mounted on Jøtul F 105 B).
Fig. 14
B
C
2. Fasten the external air connector (A) to the adapter by
inserting the two screws (B) into the track and tightening
with the nuts (C).
B B
B
A
C