Before Fi Rst Use; Use - DS Produkte 08365 Mode D'emploi

Before fi rst use
PLEASE NOTE!
■ There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it.
■ Never remove the rating plate and any possible warnings!
1. Pull any foils and stickers off of the device.
2. Clean the kettle with a damp, soft cloth (see chapter "Cleaning and Care").
3. Place the base station (4) on a dry, water and heat-resistant, even surface with suf-
fi cient space to fl ammable objects. Please ensure that the device is not accessible
to children.
4. Insert the mains plug in a properly installed and grounded socket.
5. Fill the water kettle (5) with tap water up to the MAX mark and let it boil up (see chap-
ter "Use"). Pour the water away afterwards. Repeat this process twice.
The kettle is now ready for use!

Use

PLEASE NOTE!
■ Each time before boiling, ensure that the On/Off switch is not jammed. The device
only switches off automatically, when the On/Off switch is not jammed.
1. Take the water kettle (5) off the base station (4). Open the lid (2) and fi ll the water ket-
tle with drinking water. Make sure that the water level is between the MIN and MAX
marks. If there is not enough water in the kettle, the device will deactivate before
completing the boiling process; if it is fi lled past the MAX mark, water may spray out
during the boiling process.
2. Close the lid and place the kettle on the base station.
3. Set the On / Off (3) switch of the kettle to position I (ON). The device will turn on and
the control light will illuminate. You can interrupt the boiling process at any time by
setting the On / Off switch to position 0 (OFF).
4. The kettle automatically deactivates once the water has boiled. The On / Off switch
sets automatically to position 0 (OFF) and the control light switches off.
5. Remove the power plug from the socket and take the kettle off of the base station
and carefully pour the water into a suitable container. Keep the lid closed when
pouring out the water.
If not in use, the water kettle may be stored on the base station. However, be sure to pull
the mains plug out of the socket.
15 EN