Tecnolux JC09CA16B1R290 Mode D'emploi page 61

1.1.1. take out the outer connector assembly and the exhaust pipe
assembly, and remove the plastic bags;
1.1.2. insert the heat pipe assembly (the end of the exhaust joint)
into the back panel vent slot (push to the left) and complete
the assembly (as shown above).
1.2. Installation of window sealing plate components
1.2.1. Half open the window, and mount the window sealing plate
assembly to the window (as shown in Fig.2 and Fig.3).
Components can be placed in horizontal and vertical
direction.
1.2.2. Pull various components of the window sealing plate
assembly open, adjust their opening distance to bring both
ends of the assembly into contact with the window frame, and
fix various components of the assembly.1.2 Install the window
sealing plate assembly
Notes: the flat end of the exhaust pipe joints must be snapped
into place.
1.2.3. The pipe cannot be distorted nor has substantial turning
(greater than 45 °). Keep the ventilation of the exhaust pipe
not blocked.
Figure 2
1.3. Install the body
1.3.1. Move the machine with installed heat pipe and fittings before
the window, and the distance between the body and walls or
other objects shall be least 50 cm (as shown in Fig.4).
Figure 3