Festo DPA Série Notice D'utilisation page 16

DPA-...
Please note
S Take these correlations into account:
- The pressure regulator on the DPA-... exhausts when the high pressure set
is lower than the input pressure.
- The input pressure must be at least 2 bar less than the high pressure set.
- The air consumption depends on the level of pressure set only with.
- Sufficient air volume/current on the input side the high presure remains
constant.
S
Complete the following steps:
1. Pull the adjusting knob away from the
housing (only with DPA-...-10).
2. Turn the adjusting knob 5 as far as poss-
ible in an anti-clockwise direction (status
as supplied).
3. Pessurize connection 1 on the DPA-...
with the input pressure.
4. Turn the adjusting knob in a clockwise
direction until the desired high pressure
is set.
The pressure status is monitored by addi-
tional control manometers in accordance
with the section "Accessories"
(see Fig. 11).
– Manometer (A): input pressure
– Manometer (B): high pressure
To be locked:
5. Push the adjusting knob towards the
housing (only with DPA-...-10).
16
5
Fig. 9
Fig. 10
(A) (B)
Fig. 11
Festo DPA-... 0102NH English