Festo DPA Série Notice D'utilisation page 14

DPA-...
4 Fitting
Fitting mechanical components
S
Select the fastening method for your application from the following table:
Method of fastening
Number of screws
required
Max. permitted tightening
torque
Fastening
Fig. 5
Fitting pneumatic components
Please note
Incorrectly dimensioned tubing cross-sectional areas can impair the timing
behaviour of downstream switched components.
S Use silencers in accordance with the section "Accessories".
The product will then function correctly and safely.
S
Use the minimum tubing cross-sectional areas as shown in Fig. 7.
Smaller sizes minimize the flow of the DPA-... .
S
Check whether a pressure compensation reservoir type VZS-... is necessary.
In this way you will avoid fluctuations in pressure.
14
Direct fastening
four
30 Nm
Fastening with support
bracket type HUA-...
Two each (supplied with
the HUA-...)
Festo DPA-... 0102NH English