Télécharger Imprimer la page

Vitrifrigo IM CLASSIC Mode D'emploi page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

This appliance conforms to the standards 89/336/EEC with regard to the suppression of
radio disturbances.
Before connecting the machine, make sure that the mains voltage corresponds to that
given on the machine or compressor rating plates.
This machine must be earthed in accordance with the laws in force. Make sure that
the electrical system earthing installation is in perfect working order.
The use of adapters, multiple sockets, or extension leads is not recommended. Should it
be necessary to use one of the latter, always use materials that conform to the safety
standards in force and take care not to exceed the current capacity limits stated on the
materials themselves.
In the event that the ice maker plug is not compatible with the socket, it is preferable to
replace the socket with another, more suitable type. A qualified technician, who must
ensure that the socket wiring is suitable for the electrical input of the machine, should
carry out this operation.
In the "Ice production" mode, the temperature is factory set and cannot be adjusted.
After it has been installed, the Ice Maker will run an empty cycle and then produce ice
during all subsequent cycles.
The first cubes will be dispensed after approximately 1 hour.
Open the door, remove the ice tray and pour drinking water into the tank through the
filler (K) (min. 1 litre / max. 8 litres) (see Fig. 1), checking the water level through
the relevant window (H). This operation should be carried out slowly in order to
avoid any water overflow.
Plug the machine into the power socket and switch on the main switch (A).
Connect the water mains to the threaded filler (4) on the solenoid valve (E) using the
special hose (3) supplied (see Fig. 4).
The machine is equipped to operate at a water pressure of between 1 and 3 bar.
Make sure that the water mains supply drinking water and that the pressure of the
water is sufficient to produce between 120 – 135 g of ice per cycle (the optimum
pressure is 2 bar).
We recommend fitting a shut-off valve on the water line.
16

Publicité

loading