Vitrifrigo IM CLASSIC Mode D'emploi page 16

Before cleaning the ice maker, make sure that it is not connected to the mains power
supply. If connected, unplug it.
Wash the ice maker exterior with lukewarm water, rinse with cold water, and dry with a
soft cloth. Do not use abrasive products.
Remove the ice tray (B) and proceed to clean using warm water mixed with a little
bicarbonate of soda or vinegar. Rinse carefully and dry thoroughly using a soft cloth.
Never use abrasive products, detergents or soap.
The condenser I) should be cleaned at least once a year (see Fig. 1), using a vacuum
cleaner or a dry soft brush.
The tank G) should be cleaned at least once every three months (see Fig. 1) and
proceeding as follows (see Fig. 3):
a) completely unscrew the screw (1) on the front panel (G) by turning it anticlockwise
b) slide the front panel downwards for a few centimetres and remove from the front (3)
c) remove the tank (D) being careful not to disturb the water hose or the power cable
(see Fig. 3)
d) use a screwdriver and loosen the screws (2) and remove the pump (F) from its
seating.
Clean the pump with water.
Follow these instructions in reverse order to reposition the pump in its seating and
replace the front panel, making sure that the pins on the lower fin enter correctly into
the holes on the base of ice maker.
PLEASE NOTE: when cleaning the tank, be especially careful of the sharp surfaces
In the even that the machine is to stand idle for long periods, to avoid the formation of
mould or bad smells:
 unplug the ice maker from the mains power supply
 empty the ice tray (B) completely
 empty the tank (D) completely (see Fig. 1)
 clean the inside and leave the door half open.
15