Lenze 9400 E94ASHE Série Instructions De Montage page 75

Pos.
S1
O
N
d c b a
Baud
Fig.16-7
On memory modules with front-panel DIP switches you can set
the node address (labelling "1" ... "64") and
ƒ
the baud rate (labelling "a" ... "d").
ƒ

Note!
If all address switches are in the "OFF" position when the standard device is
switched on, the configurations stored under codes C00350 (node address)
and C00351 (baud rate) are valid.
Switch off the voltage supply of the standard device and then switch it on
again to activated changed settings.
Setting of the node address
The node address of the drive results from the sum of all address switches in ON position.
Setting of the baud rate
d c
OFF ON
OFF ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON ON
OFF ON
OFF ON
EDK94ASH24 DE/EN/FR/ES/IT 3.1
Labelling Description
1 ... 64 Node address
a ... d System bus (CANopen) baud rate
64 32 16 8 4 2 1
CAN Address
Arrangement and labelling of the DIP switches
b a Baud rate
ON OFF 10 kbps
OFF ON 20 kbps
ON ON 50 kbps
ON OFF 125 kbps
OFF ON 250 kbps
OFF OFF 500 kbps
ON OFF 800 kbps
OFF OFF 1000 kbps
ON ON Autobaud

Wiring the device modules
Memory modules
8
9400CAN003
75