Lenze 9400 E94ASHE Série Instructions De Montage page 61

System bus CAN on board
Terminal X1
9400SSP000X1

Note!
The "StateLine" design does not provide this connection.
24 V supply
Terminal X2
9400SSP000X2
Terminal data
Flexible
With wire end
ferrule
EDK94ASH24 DE/EN/FR/ES/IT 3.1
Labelling Description
Pin 2 CAN-LOW
Pin 3 CAN-GND
Pin 7 CAN-HIGH
(Housing) CAN-Shield
Labelling Description
GE GND external supply
24E 24 V external supply via a safely separated power supply
unit (SELV/PELV) (only required for mains-independent supply of the
control electronics)
SB State bus in/out (reference GE)
Conductor cross-section
2
[mm ]
0.2 ... 2.5

Wiring the standard device
Tightening torque
[AWG] [Nm]
24 ... 12
7
[lb-in]
Spring terminal
61