Important Safety Instructions; Technical Data - Cooper Hand Tools Weller PYROPEN Piezo Manuel D'utilisation

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of injury or property damage, READ AND UNDERSTAND the
following warnings.
1. Check tools for damage before use.
2. If damage is found, the device must not be used and the tank must not
be refilled.
3. Do not fill gas or store near open flame, heater, furnace or combustible
materials.
4. Use only non-aromatic butane gas as recommended by the manufacturer.
5. Be sure to put switch down after use.
6. Use only in open air place or well ventilated place.
7. Avoid dropping or causing a hard shock.
8. Do not use iron holder designed for the electrical iron. This may cause bur-
ning of tool body.
9. Do not store under direct sunlight or anywhere that will exceed 40°C or
140°F. This will cause fire / explosion as gas pressure become high.
10. Do not store near windshield, in trunk of car.
11. Keep out of reach of infants.
12. Keep hands and combustibles clear out of exhaust opening and tip housing
to avoid burns or fire.
13. Do not immerse in water.
14. Do not try to disassemble or misuse or alter or tamper.
15. Do not wipe soldering iron with alcohol-based cleaner.
16. Cool down before putting protective cap on.

TECHNICAL DATA

F
Tip housing
Hot air exhaust
hole
CAUTION: Keep
clear as hot air
comes out here
C
Window
G
Soldering tip (or hot
blow nozzle)
Specifications
Length incl. soldering tip:
Weight incl. gas filling:
Temperature values:
Burning time per gas filling:
Filling quantity:
GB
D
Gas OPEN / CLOSE
main lever
B
Ignition button
E
Knurled nut
265 mm / 10 7/16"
126 g / 4.4 oz.
Soldering iron 250° - 500°C / 482° - 932°F
Hot blow 650°C / 1202°F
4 hours with gas control lever set at 2.
28 cc / 1.71 cu. inch
A
Control lever position for
adjusting gas flow and also
tip temperature
Gas level window
Handle contai-
ning butane gas
Gas refill-nozzle
14