Horizon Fitness ANDES 2.0 Manuel Du Propriétaire page 16

ASSEMBLY STEP 3
4
6
2
16
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
5
7
G
H
B
I J
8
HARDWARE FOR STEP 3
PART TYPE
G WAVY WASHER
H FLAT WASHER
I FLAT WASHER
B SPRING WASHER
J BUTTON HEAD BOLT
A Open HARDWARE FOR STEP 3.
Remove PRE-INSTALLED BOLTS AND WASHERS (6)
B
from MAIN FRAME (2).
C Carefully pull the CONSOLE CABLE (4) through the
CONSOLE MAST (5) using the twist tie located inside
the CONSOLE MAST (5).
D Attach CONSOLE MAST (5) to MAIN FRAME (2) using
PRE-INSTALLED BOLTS AND WASHERS (6).
E Slide WAVY WASHER (G) and FLAT WASHER (H) over
CRANK (7) followed by PEDAL ARM (8) as shown. Rest
pedal arm wheel on guide rail.
F Attach the PEDAL ARM (8) to the CRANK (7) using
1 FLAT WASHER (I), 1 SPRING WASHER (B) and 1
BOLT (J).
G Repeat steps E–F on the opposite side of the elliptical.
DESCRIPTION QTY
17.2X22.5X0.5T 2
16.0X25.0X1.0T 2
8.2X30.0X1.5T 2
8.2X15.4X2.0T 2
M8X1.25PX15L 2