Horizon Fitness ANDES 2.0 Manuel Du Propriétaire page 13

TOOLS REQUIRED:
F 8 mm L-Wrench
F 13/17 mm Flat Wrench
F 5 mm L-Wrench/Screwdriver
F Screwdriver (not included)
PARTS INCLUDED:
F 1 Main Frame
F 1 Stabilizer Tube
F 1 Guide Rail Set
F 1 Console Mast
F 2 Pedal Arms
F 2 Lower Handlebars
F 2 Upper Handlebars
F 2 Handlebar Cover Sets
F 2 Lower Link Arms With Footpads
F 1 Front Top Cap Piece
F 1 Rear Top Cap Piece
F 1 Console
F 1 Audio Adapter Cable
F 1 Power Cord
F 1 Hardware Kit
PRE ASSEMBLY
UNPACKING
Unpack the product where you will be using it. Place the elliptical carton on a level
flat surface. It is recommended that you place a protective covering on your floor.
Never open box when it is on its side.
WARNING
• It is recommended that two people work together for ease and efficiency
while assembling an elliptical.
• During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded. It is recommended you complete the full assembly of
your unit before completely tightening any ONE bolt.
• Several parts have been pre-lubricated to aid in assembly and usage. Please
do not wipe this off. If you have difficulty, a light application of lithium bike
grease is recommended.
NEED HELP?
If you have questions or if there are any missing parts, please refer to safety
sticker on product to contact Customer Tech Support.
13