wtw Cond 330i Mode D'emploi page 8

Determining/Setting the cell constants
C A L
1/ cm
0 7 4 3
Tref25
Cal
C L E L
6 8 0
S/
1/
0 1 6 4
Tref25
ARng
nLF
C L E L
9 2 5
S/
1/
0 1 0 0
Tref25
ARng
nLF
8
l Press <RUN/ENTER>. The AutoRead measurement begins.
l If the measured value is stable, the instrument displays the determined
cell constants and the calibration evaluation. The measuring instrument
automatically stores the cell constants.
l Switch to the measuring mode with <M>.
Procedure for manually setting the cell constant:
l Press the <CAL> key repeatedly until the
l Then press the <RUN/ENTER> key.
l Press the <CAL> key until a measured value and a value for the cell con-
stant appears in the required setting range.
cm
l Set the value of the cell constant with < > < >.
cm
l Switch to the measuring mode with <M>.
Procedure for selecting fixed cell constants 0.010 cm
l Press the <CAL> key repeatedly until the
l Then press the <RUN/ENTER> key.
l Press the <CAL> key until a measured value and the cell constant
-1
0.010 cm
cm
l Switch to the measuring mode with <M>.
cm
appear.
Cond 330i/340i
CELL display appears.
-1
:
CELL display appears.