Wifi Function - DeLonghi EL Série Mode D'emploi

Masquer les pouces Voir aussi pour EL Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING FROM THE CONTROL PANEL
TURNING THE APPLIANCE ON/OFF
tioner by simply pulling the plug. Touch the
put your air conditioner in stand-by and wait a few minutes be-
fore pulling the plug. In this manner, the appliance can perform
operating status checks.
MODE SELECTION

WiFi FUNCTION

Before plugging in the appli-
ance, check the caps on back of
the unit are correctly inserted
on drainage hose A11 and A13.
Insert the plug in the socket.
Two dashes appear on the display
indicating that the appliance is in
stand-by. Touch the
(C1) key to
turn on the appliance. When the ap-
pliance comes on, the last function
set before it was shut off is activated.
NOTE: After a few seconds of inac-
tivity, the brightness of the control
panel will be automatically reduced
and in the next few minutes it will
be further reduced. To turn the ap-
pliance off, touch the
Note: Never turn off the air condi-
key in order to
To select the desired operating
mode,
touch repeatedly the
MODE key until the desired function
is selected.
To select or deselect the Wifi func-
tion, keep touching the MODE key
for 3 seconds.
AIR CONDITIONING MODE
significantly lower than the outdoor temperature is not recom-
mended. In air conditioning mode, the air flow can be selected
only from the remote control.
DEHUMIDIFYING MODE
key.
the appliance to allow the humidity to be discharged outside. To
correctly set this mode:
• Touch repeatedly the MODE key until the dehumidifying
symbol
• The appliance automatically chooses the best air flow.
Note:
In case of high ambient humidity, it is possible to drain the
condensation continuously by applying the tube supplied B11
to the upper drainage hose A13 (fig. 7) and thus allowing the
water to flow into a container.
Unscrew the cap by following the directions and inserting the
tube. Pay attention that water does not overflow onto the floor
(fig. 8). If the connector is not in use, to avoid overflow onto the
floor, remember to screw the cap back into place.
9
This is ideal for hot and humid weather
when the room needs to be both cooled
and dehumidified.
To correctly set this mode:
• Touch repeatedly the MODE key un-
til the air conditioning symbol
appears.
• To change to the desired temper-
ature, touch the
Note: The most suitable temperatures,
during the summer range from 75 to
81°F. However, setting the temperature
This is ideal for reducing humidity
in the room (spring and autumn,
damp rooms, rainy periods, etc).
For this type of use, the appliance
must be set up same as in the air
conditioning mode. That is, the air
exhaust hose B3 must be fitted to
appears.
or
key.
7

Publicité

Table des Matières
loading

Table des Matières