DeLonghi EL Série Mode D'emploi page 7

Proceed as follows:
• Drill a hole ø 5,25 inches (134 mm) in an outside wall or
through a wooden kickboard. Respect the dimensions and
height of the hole given in figure 2 and 3.
3
in the wooden
kickboard of a French
window or panel
• Fit the wall flange B1 into the hole.
• Fit the assembled hose B3 into the wall flange B1.
When the air hose B3 is not connected, the drilled hole can
•
be closed with the flange cap B1.
• When installing the air conditioner, you should leave a door
slightly open little as 1/2"(1 cm) to guarantee correct ven-
tilation and room pressure.
• Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
As special tools are required for this type of installation,
we suggest you have the appliance installed by special-
ized personnel.
AIR CONDITIONING WITH WINDOW INSTALLATION
You can also set up in a double-hung window:
• Place the window bracket in the window sill, extend the
bracket fully within the window frame, fix the bracket in
place using the locking pin. Attach the provided foam strip-
ping B10 to the top of the window bracket and then lower
the window onto the bracket. (Should the window bracket
be too large for the window, the plastic can be cut with a
saw by a qualified professional.)
• Fit the air exhaust hose B3 in the relevant housing located
on the rear side of the appliance. Align the open lock sym-
bol on the air hose with the arrow on the back of the unit,
turn air hose counter clockwise until the closed lock symbol
is aligned with the arrow, as shown in figure 1
in the wall:
you are
recommended to insulate the
section of wall using
suitable insulation
• Connect the window outlet vent B2 to the other end of the
exhaust hose.
Insert the window outlet vent B2 of the exhaust hose into
•
the slot of the window bracket (fig. 4).
4
Other set-up methods:
• Thanks to the locking pins, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see fig. 5).
5
• If you have a casement window (figure 6) proceed as fol-
lows:
Fit the assembled air exhaust hose B3 in the relevant hous-
•
ing located on the rear side of the appliance, align the open
lock symbol on the air hose with the arrow on the back of
the unit, turn air hose counter clockwise until the closed
lock symbol is aligned with the arrow, as shown in figure 1,
then, apply the window outlet B2 to the air exhaust hose
B3 and place it outside the window to exhaust the hot air.
7