Usb Memory Device Compatibility; Connecting Antennas (Am) - Teac DR-H338i Mode D'emploi

Masquer les pouces Voir aussi pour DR-H338i:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USB memory device compatibility

< Only USB flash memory can be used. Do NOT use a high-capacity
USB hard disc with this unit.
< Some flash memory players that charge from an USB terminal
cannot be played back.
< Hard disk drives, CD/DVD drives, and other devices than flash
memory connected via USB cannot be used.
< The DR-H338i cannot copy, move, or delete files.
< Playable format: FAT12, FAT16, FAT32
< NTFS, HFS, HFS+ cannot be used.
< Max. number of playable folders: 300
< Max. number of playable files: 650
8

Connecting Antennas (AM)

AM indoor loop antenna
The supplied high-performance AM loop antenna provided with
this unit is sufficient for good reception in most areas.
To stand the loop antenna on a surface, fix the claw to the slot in
the antenna base.
Connect the loop antenna's wires to the AM antenna terminals.
Press the lever, insert the end of the cord, then release the lever.
Make sure it is fastened securely by pulling the cord lightly. Make
sure only the bare, stripped wire is inserted in the jack and that no
plastic insulation is preventing contact between the antenna wire
and terminal.
Place the antenna on a shelf or hang it on a window frame, etc.,
in the direction which gives the best reception. Keep all other
wires such as power cords, speaker wires or interconnect wires as
far away as possible from the antenna.

Publicité

Table des Matières
loading

Table des Matières