Listening To The Radio (Fm/Am) - Teac DR-H338i Mode D'emploi

1
Select "FM Radio" or "AM Radio" using the SOURCE
button.
< You can also select "FM Radio" or "AM Radio" by pressing the
TUNER button on the remote control unit once or twice.
2
Hold down the TUNING button ( . or / ) for more
than 1 seconds to select the station you want to listen to
(Auto selection).
Hold down
more than 1 sec.
The unit starts searching for a station.
When a station is tuned in, the tuning process will stop
automatically.
Repeat this step until the station you want to listen to is found.
< If you want to stop the tuning process, press the TUNING button.

Listening to the Radio (FM/AM)

Selecting stations which cannot be tuned automatically
(Manual selection)
When the TUNING button is pressed momentarily, the frequency
changes by a fixed step.
Press the TUNING button repeatedly until the station you want
to listen to is found.
FM MODE
Pressing this button alternates between Auto (Stereo) mode and
Mono mode.
Auto Mode
FM stereo broadcasts are received in stereo.
Mono Mode
To compensate for weak FM stereo reception, select this mode.
Reception will now be forced to monaural, reducing unwanted
noise.
If the reception is poor
For the best reception, rotate the FM antenna or AM antenna until
you get stations clearly.
43