Connection To Audio Equipments Etc - Teac DR-H338i Mode D'emploi

After all connections are complete, connect the power cord's plug to the AC wall socket.
< Read the instructions of each component you intend to use with this unit.
< Be sure to connect each plug securely. To prevent hum and noise, do not bundle the connection cords.
Wall socket
Power cord receptacle
A
After all other connections have been made, insert the supplied
AC power cord into this receptacle, then connect the other
end of the power cord into the wall socket. Ensure that your AC
voltage corresponds to the voltage marked on the rear panel of
the unit. Consult a qualified electrician if you are in doubt.
In order to avoid the risk of electric shock, fire, and so on, only
use the supplied power cord.
< If you are not going to use the unit for some time, disconnect the
power cord from the wall socket.
B AUX 1/LINE OUT jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect a cassette tape deck etc. to these jacks using
commercially-available RCA cables.
Make sure to connect:
White plug White jack (L: left channel)
e
Red plug Red jack (R: right channel)
e

Connection to Audio Equipments etc.

B
A
Cassette tape deck etc.
C
Digital audio device
(CD recorder, MD deck, etc.)
iPod port
C
Connect the iPod dock to this port.
D Digital audio output terminal
Digital audio from DVD-Video, CD and video CD is output from
this terminal.
Connect an amplifiers including a decoder, or digital audio
devices such as CD recorders, etc. to this jack using commercially-
available optical digital audio cable (TOS).
< Select "ALL" or "PCM only" in the DIGITAL AUDIO SETUP (page 39).
D
11