Teac DR-H338i Mode D'emploi page 49

iPod player
Cannot insert the iPod.
e Check if appropriate adapter is inserted to the dock (page 22).
e Remove dust or obstacles from the dock and the iPod.
The iPod does not play.
e Remove the iPod from the dock, wait a few seconds, and insert it
again.
e Software update may solve the problem.
Cannot operate the iPod on the components.
e Select iPod as the source.
Cannot operate the iPod.
e Make sure the HOLD switch of the iPod is not set to HOLD.
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again. This resets the internal
micro-computer which can be disturbed during electrical
storms, power interruptions, etc.
If unplugging the power cord does not solve the problem, try the
following procedure to reset the internal micro-computer.
1. Turn the unit on.
2. Press the Stop button (H) while holding down the Play/Pause
button (y/J).
3. Release the Stop button (H) when "DR-H338i**" appears on the
display.
4. Release the Play/Pause button (y/J).
5. Press the Stop button (H).
Hold down
49